I use two screens. I like having the plan on one and the elevation or section on the other. However, when I switch from one window to the other (by clicking on that window) it changes that windows layer settings to the settings from the window I was previously on. I know that the simple solution to this is to click on the View in the Navigator to go between drawings but is there a way to set it up so I can just jump between windows and have each window hold it's own view settings? When I'm going back and forth between drawings a lot it would be convenient to be able to do this. If this is not possible, is there a way to add multiple trace references in a window? That way I wouldn't have to jump between windows at all. As far as I know the answer to these questions above is "No." If this is true then the above is not a question, it is my wish.
Thank you
www.michaelgustavson.com Architect NY WI IL
Madison WI
Archicad21 MEP EcoDesSTAR Win10-64-bit
EliteBook8570W Corei7-3630QM@2.40GHz
QuadroK2000m RAM32 (2)250GBSSDs
4 Monitors Internet:4Up60Down