Modeling
About Archicad's design tools, element connections, modeling concepts, etc.

Cyrillic not supported in AC12 too!

Anonymous
Not applicable
AC12 does not have proper support for Cyrillic characters! So did AC11!

Today I opened an AC10 file and came upon a great mess! The file was practically unusable!

All layout names, views names, zone stamps, section names and ID's and door-makers written in Cyrillic were unreadable mess of characters! I opened the file on in AC10, on the same computer and it was ok! I resaved it and opened it again in 12 and had the same mess!

I have reported the same behavior in AC11, but it seems nobody cares:
http://archicad-talk.graphisoft.com/viewtopic.php?t=23129&highlight=

Dear Graphisoft/Nemecheck, I know you don't care about a small market as Bulgaria! There is not a Bulgarian version and probably there will never be any! But there are also other markets that use Cyrillic alphabet and they are not small. They are Russia, Ukraine, Belarus, etc., so you should care!
0 REPLIES 0