Wishes
Post your wishes about Graphisoft products: Archicad, BIMx, BIMcloud, and DDScad.

MEP routing

Anonymous
Not applicable
There is missing in routing options bend type which would not make bend but cut down both connected ducts. This is used mostly for air distribution system built in floors. For explanation look at the picture...

MEP_ROUTING.JPG
1 REPLY 1
Thomas Holm
Booster
Radovan wrote:
There is missing in routing options bend type which would not make bend but cut down both connected ducts. This is used mostly for air distribution system built in floors. For explanation look at the picture...
I'm not just an architect, I'm a certified quality controller too.
I think it's a GoodThing™ that GS has left out an option which is almost impossible to make air-tight, which is (or should be) a requirement for this kind of duct. Functionally, the Square Throat option is identical, and that's what you should use!
AC4.1-AC26SWE; MacOS13.5.1; MP5,1+MBP16,1