Towel Ring 01 11....2D plan view not showing....

junior wrote:
Just a note: I mentioned 'Towel Ring' ...not the 'Towel Bar'.

My bad.

With the Towel Ring object, the problem is in the 2D Script:

POLY2_B{2} 5, gs_cont_pen,gs_fill_pen, gs_back_pen,
0, 0, 0,
0,0,3,
0,-di*0.2,3,
di,-di*0.2,3,
di,0,3,
0,0,3

where the gs_cont_pen should be the frame_fill argument (for all of the POLY_B{2} commands), if this is changed to 3 (j1 (1): contour only + j2 (2): fill only, see page 120 of the AC11 GDL Reference Guide) the 2D will appear as expected (though I have not tested with all the other parameter options). The writer of this part had the project2 3,270,2 command commented out (probably for checking his 2d work against the 3D part) at the top of the 2D Script: while this will give you a top down 2D view of the 3D of the part, there is a performance hit (probably not noticeable with just a few instances of this part), so the 2D commands are preferable to the project2 route.

Are you the first one to use this part, how did no one else see (not see) this?

David

junior wrote:
Moderators - Let the guys at the 'top' know about this issue, Thanks!

Done.

Cheers,
Link.