Modeling
About Archicad's design tools, element connections, modeling concepts, etc.

Door open inwards aligned to wall exterior side

Anonymous
Not applicable
Hi,

I am trying to draw a door that open inwards, but is aligned with the exterior side of the wall.

I tried a lot of them, but I could not figure any combination of parameters of the AC standard doors, that produce this result. (I've also searched the forum with no luck)

Does anybody knows if it is possible? or the only solution is to build my own object?

Thanks

Door_in_wall_outside.jpg
2 REPLIES 2
Anonymous
Not applicable
You need to play around with the reveal setting in the General settings.
Pay attention to the wall type setting because with certain wall types
the reveal setting is grayed out.
Peter Devlin
Thomas Holm
Booster
Quite possible.
Peter wrote:
You need to play around with the reveal setting in the General settings.
Then check the "Flip" checkbox.

(This is out of my head, can't check right now, sorry if I'm wrong)
AC4.1-AC26SWE; MacOS13.5.1; MP5,1+MBP16,1