2009-02-04 06:18 PM
2009-08-04 09:15 AM
2009-08-04 10:07 AM
2009-08-04 10:09 AM
2009-08-04 12:15 PM
Peter wrote:Take a look at OBJECTiVE. It gives you very detailed control over the end conditions of profiled shapes using a
The ends can only be vertical which means sloped beams don't join neatly.
The blue beam shows how this could look if you could adjust the angle of the ends. I faked this simple square section beam using the roof tool, but it would be good if we had a solution that used complex profiles as well.
... this would be seriously useful for facia and soffit boarding, and edge mouldings etc.
2009-08-04 01:39 PM
2009-08-04 01:46 PM
2009-08-04 06:21 PM
Valery wrote:I merged this duplicate with with the original, identical wish ... but in the process, the 8 'essential' votes from the new list were lost. Messages merge, but votes do not.
We need more voices here. Then, ask the moderator to join the topic. Voices of the two Wishes will be added!
2009-08-04 07:13 PM
2009-08-04 07:19 PM
Gerald wrote:Well, we'll find out if GS is actually listening to our WISHES.
hopefully it's in v.13!
2009-08-04 10:07 PM