Section doesn't show skin separator lines

Anonymous · ‎2009-08-20

I can't get the skin separator lines to display in my sections. What am I doing wrong?

The attached image explains it best, I think.

Erika Epstein · ‎2009-08-21

In general, Check over-ride fills and then you will have this option available.

I am not sure which wall you are unhappy with.

Erika
Architect, Consultant
MacBook Pro Retina, 15-inch Yosemite 2.8 GHz Intel Core i7 16 GB 1600 MHz DDR3
Mac OSX 10.11.1
AC5-18
Onuma System

"Implementing Successful Building Information Modeling"

Anonymous · ‎2009-08-21

None of the separator lines are showing, so it's all of them that I'm unhappy with. I've tried every variation on Model View Options with no luck.

Rod Jurich · ‎2009-08-21

LINZ wrote:
/.. What am I doing wrong? /......

Lindsay, you need to have a different name for the finish skin to show the separator line.
If the finish skin is to be the same fill as the core you will need to have a
different named fill, core fill 1, core fill 2.

Rod Jurich
AC4.55 - AC14 INT (4204) |  | OBJECTiVE |

Anonymous · ‎2009-08-21

Thank you very much! I didn't know that was the case...

Section doesn't show skin separator lines

Still looking?

Browse more topics

See latest solutions

Start a new discussion!